Tried that it did not work.
Everything is fine on start, but after a reload of game.
Everything seems turned back on to visible.
These are all things that are setup through Quest machine where certain nodes would turn Visible (get quest go here)
Then back off (Finish quest, or node true etc.)
Compass Navigator Pro 2 (just released)
-
- Posts: 93
- Joined: Wed Jan 22, 2020 1:20 pm
Re: Compass Navigator Pro 2 (just released)
Do you have any idea what mind be re-enabling the POIs? If you remove the POI Saver components (as a test), does it not re-enable the POIs?
-
- Posts: 93
- Joined: Wed Jan 22, 2020 1:20 pm
Re: Compass Navigator Pro 2 (just released)
Will test right a few things
Set the POIS as disabled
1.) Remove the POIS Saver component.
2.) remove the quest tracking component.
3.) Combo of both removed
4.) Try actually filling in fields, or leaving empty on the quest track component.
See what if anything is turning on after reload.
Set the POIS as disabled
1.) Remove the POIS Saver component.
2.) remove the quest tracking component.
3.) Combo of both removed
4.) Try actually filling in fields, or leaving empty on the quest track component.
See what if anything is turning on after reload.
-
- Posts: 93
- Joined: Wed Jan 22, 2020 1:20 pm
Re: Compass Navigator Pro 2 (just released)
UPON TESTING
The quest tracking script is the culprit. After updating to new version all of the fields that were filled in are blank.
If that is left blank then upon reload things will be turned on.
I am just going to remove that script from the POIS and should be good to go
The quest tracking script is the culprit. After updating to new version all of the fields that were filled in are blank.
If that is left blank then upon reload things will be turned on.
I am just going to remove that script from the POIS and should be good to go
Re: Compass Navigator Pro 2 (just released)
Great job tracking down the culprit! I don't recall which quest tracking script that is, but you might be able to modify it to not cause the issue, if you still need to use the script.